My testing so far.

The grey one was printed with 10sec exposure. The greens that worked with 7sec (monocure rapid at 0.05mm). The incomplete one was one of my two fails. This one was a try how far I could reduce exposure (5sec per layer). The other one that failed had a mistake in the model file.

So as far as i'm concerned the fhd works pretty well. The amout of detail is awesome and there is practically no visible stepping. Fails I've had were not because of the machine.

I gave the minis an acrylic wash to make the details more visible. Oil would have been much better but I want to prime and paint them soon. So drying time is crucial.

SparkMaker FHD

The Most Affordable FHD SLA 3D Printer57μm XY resolution | 61.8*110*125mm build volume | 20-25mm/hr

The Most Affordable FHD SLA 3D Printer
57μm XY resolution | 61.8110125mm build volume | 20-25mm/hr